Installing an air conditioner can be a daunting task, but with the right guidance and preparation, it can be a breeze. This comprehensive guide will walk you through the four steps of installing and evaluating your old air conditioning system, installing the new one, installing or inspecting your thermostat, and running the oven before turning on your air conditioner for the first time. The first step in the process is to remove your old air conditioning system. This includes disconnecting the power supply, draining the coolant, and disassembling the unit.
Once this is done, you can begin to install the new air conditioning system. The next step is to install or inspect your thermostat. This is important as it will control the temperature and humidity inside your home. Make sure that the low voltage control cable is connected directly to the air conditioner condenser in the appropriate locations according to the air conditioner condenser installation instructions. The third step is to place the line set. Usually, an installer will start with the suction line and extend one end a few meters, leaving the rest of the roll on a coil.
They then push the unrolled section through a hole drilled in the house plate to the outside, near the air conditioner. A sufficient part of the line is pushed to reach the air conditioner service valve. The fourth step is to install or inspect your thermostat. Make sure that the low voltage control cable is connected directly to the air conditioner condenser in the appropriate locations according to the air conditioner condenser installation instructions. The fifth step is to run the oven before turning on your air conditioner for the first time. Isolating the coolant avoids having to replace it with a completely new coolant in the event of a future repair. Finally, you must ensure that all members of your installation team have their own individual certification from the EPA. All good HVAC companies have strict processes in place so that their installation teams avoid faults as much as possible. In conclusion, installing an air conditioner can be a complex process but with proper guidance and preparation, it can be done quickly and efficiently.
Make sure that you follow all of these steps carefully and that all members of your installation team have their own individual certification from the EPA.
